How to deal with the problem of the slip line

The purchaser should pay attention to the quality problem when selecting the sliding line manufacturer and purchasing the sliding contact line. The high quality sliding contact line will have less maintenance work in the later stage, shorten the maintenance period, and understand how to deal with the problem of the sliding line fault to further improve himself. The knowledge side can not only have a deeper understanding of the sliding line, but also prepare for the post-maintenance work.

1. Sparks appear between the sliding line and the conductor

There may be many reasons for sparks, such as poor contact between the brush wire surface and the guide rail, the contact area does not meet the requirements, and the collector should be worn seriously. Should it be replaced with a new one, the sliding contact housing, the conductor material, and the collector carbon. Whether the percentage of brushed copper carbon is acceptable or not is a common factor causing the occurrence of fireworks. Therefore, caution should be exercised when selecting the manufacturer of the sliding line.

2. The multi-pole sliding contact line is obviously deformed, so that the collector cannot move.

Affected by environmental factors, such as the temperature is too high, or the hanging clips are stuck on the sliding wire casing, so that the thermal expansion of the sliding contact line cannot be extended, and the influence of factors such as excessive spacing or looseness of the fixing clips causes the multi-pole sliding contact line to appear. Obvious deformation, multi-pole slip line deformation will hide a lot of safety hazards, regular inspection is important, timely correction in the course of use can also prevent problems before, if the temperature is high, you can add rain cover outside, at the same time Adjust the lifting clip so that the sliding wire can be freely extended, add the fixing clip, or set the fixing clip according to national standards and correct it.